Quick Coupling technique for connecting two lengths of the Ductall® Vinyl Hose

Advance the wire from one end of the hose pieces by pulling it with pliers. This will reduce the hose diameter slightly.
Snip off the exposed wire close to the vinyl covering. Then bend the remaining end of the wire back inside the vinyl covering.
Cement can be applied outside this prepared section should a more positive seal be desired. Screw the prepared section of the hose into the hose to be joined with it by rotating it counterclockwise. Joint will be secure upon completion of 2 or more full turns.
When connecting hoses, ensure the inner joint is downstream with the flow.

Title: Quick Coupling technique for connecting two lengths of the Ductall® Vinyl Hose
Description: Waste can be eliminated by joining and using short lengths of the same diameter hose. To join two pieces, use the following procedure:
Published: 5/7/2009
Last Edited: 12/30/2022

Was this article useful to you?

Yes

Share

Information disclaimer:

The information contained in this article is for general information purposes only. The information is provided by United States Plastic Corp. and while we endeavor to keep the information up to date and correct, we make no representations or warranties of any kind, express or implied, about the completeness, accuracy, reliability, suitability or availability with respect to the website or the information, products, services, or related graphics contained on the website for any purpose. Any reliance you place on such information is therefore strictly at your own risk.

In no event will we be liable for any loss or damage including without limitation, indirect or consequential loss or damage, or any loss or damage whatsoever arising from loss of materials, time or profits arising out of, or in connection with, the use of this information.